Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by G_Alex

  1. G

    Cylinder design pressure for aftermarket 4 stroke cylinder.

    I have looked around at what established companies are doing for the bike in question, Most are just boring out stock cylinders and redoing the coating but . I have adjusted my cylinder wall (one piece aluminum with nikasil coating) to a larger major diameter slightly to make up the wall...
  2. G

    Cylinder design pressure for aftermarket 4 stroke cylinder.

    My customer only wants a small batch to start. The shop I work at is setup for machining welding and heat treat only, before I got involved my customer had previously finished a working liner/case cylinder design for a similar bike of a different make, and gave me that package as reference along...
  3. G

    Cylinder design pressure for aftermarket 4 stroke cylinder.

    Hi there, I have been tasked with designing a big bore cylinder for a 13:1 compression ratio 450cc single-cylinder 4-stroke MX engine making ~65 bhp. I am trying to decide what reasonable static cylinder pressures I should use in Inventor stress analysis. I don't have any other FEA, CFD, or CHT...
See more

Part and Inventory Search

Back
Top