Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Francescoing

Impact Test

I'm designing a vessel with different thickness(from 24mm to 80mm). The vessel material is SA 516 Gr.70. The Client's request is that the impact test shall be made at -45°C, for all thickness. I read the code (SA 20 - Paragraph 12.1.5) and i verified that the test shall be conducted at a...
- Francescoing
- Thread
- Sep 25, 2008
- Replies: 1
- Forum: Boiler and Pressure Vessel engineering
Corrosion Flange

Thank you for early reply. I must to know whether the corrosion allowance is applicable for flange thikness where gasket seat in case of confined joint. Thank you
- Francescoing
- Post #3
- Jul 11, 2008
- Forum: Codeware: COMPRESS
Corrosion Flange

In the calculation of Flange what is the different between Bore Corrosion and Flange Corrosion?
- Francescoing
- Thread
- Jul 10, 2008
- Replies: 4
- Forum: Codeware: COMPRESS

Part and Inventory Search

Top Bottom