Hi all,
I am looking for a simple way to design powerpacks.I am puting together a file for a client to assist him in the training of his floor staff and we feel if they are able to learn more about the machinary they would be able to look after it better.All I have looked at asume you know what...
Hi MrStout
Are you able to give a composition of the soil/oil mixture we have a way to remediate soils and make high nitrate fertelizer out of them.I would need to check with our chemist of it would work oi your case.
best
Robert
robertf@nkosiindustrial.co.za
Hi Known100,
We are looking at doing just what you have indicated,when we are completed the end result is nitrate rich soil.We call it land farming.
best
Robert
Hi KRS Services,
We have aclient who has been told to fit a grease trap to his EMV wokshop.I am looking for examples of types as he has been quoted increadable sums to put on in.I understand that the volume odwater is a factor in the sizing.
Are you able to poit me to a free source od how to...
Hi
We are a small company and part of our offer to our clients is to maintain their lubrication systems. They asked us to see if we would like to add the lube to the deal. The range of clients goes from mines to Industrial plants.
Best
Robert
Hi,wwwautolubricatorcom,
Hi great to hear from you...
Yes I would like to hear about the possible uses.All persons we have spoken talk about high speed bearings where we want to do low speed Mill bearings.
Yes we would like to know more...the client would like to where possible re-use any of...
Hi enginehead,
You do not mention where you are and what type of engine they are.I have come across this problem before but the weather had somthing to do with it.We improved the intake by fitting submicron filters...the same we use to filter the diesel and found an improvement.drilling...
Hi all,
We have picked up a problem with a pump in the chemical industry.The pump has had a Inpro-vbx bearing isolator fitted.The pump has constant oiler and a normal breather.The client is complaning that the oil is draining off to quickly from the constant oiler into the pumps housing.The oil...
Hi All,
We are looking for HELP from any person who might have done some work on Pistons been pushed through lubricatd "o'ring or "U"seal.The pressure on the seal would be between 30 and 300 bar.The size of the piston would be is 3 or 6 mm(1/8 or 1/4).The force would be hydraulic...
Hi All,
A client has asked me to find out more regarding AIR/OIL lubrication systems.He is in the steel industry and would like feed back as to how effective it is.Can anyone assist with this.the information given y the Lubrication equipment suppliers does not give a clear picture.
best
Robert...
Hi
A client of mine is looking for more information on AIR/OIl lubrication systems.The industry will be the steel, rolling mills.I am looing for any person who uses the process at present.
best
Robert
Hi "gautam15"
Well i went to the site you put and came up nought.If i am correct these profiles are for what and could be used in what industry
Best
robert
Hi icw,
please would you send to me the report you did.I had a major computer failure and the people who did the repair thought i had backed up so when they cleanded and installed a new hard drive i lost all.
many thanks
robert
ferreiro@mweb.co.za
Hi gunnarhole,
Yes i have looked but they have nothing to realy offer.I want to measure one out let and have gone the grease block route and find it very poor.
Thanks]
robert
