Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by fabien2121

  1. fabien2121

    pipeline slope

    the Miter bend or angle offset is acceptable in pipeline ?
  2. fabien2121

    pipeline slope

    we have sch 30 pipe (8.38 mm ).
  3. fabien2121

    pipeline slope

    3 degrees over a 20m length
  4. fabien2121

    pipeline slope

    Dear expert; It's possible and acceptable to make slope (3 degree & length 20 m ) in trench of pipeline instead of cold bend . Pipe diameter is 12 inches. Thanks in advance
See more

Part and Inventory Search

Back
Top