I am using SW07 COSMOSMotion and am having trouble with the joints disappearing, actually it's more that they only appear during dynamic rotation of the parts.
When I rotate the assembly the joints and center of gravity symbols show up but disappear as soon as I stop rotating and I am not...
Thanks for all of your help. Trying to replace this odd pinion is turning into quite the endeavor. Tell me what you think about this. Currently the pinion drives a 58 tooth change gear, (a 58 tooth spur gear to 9 tooth #60 roller chain sprocket that turns the davit). I am thinking about...
Diskullman,
I think the answer is the BG 6 tooth pinion. Before ordering, I want to make sure that this is a 6 pitch gear. The mating gear to the oddball 7 tooth is a 58 tooth gear with an OD of 9.75" and an ID of 9.125", and what appears to be about .125" clearance.
I have the ability to...
Thanks for the help Philrock. It may take a few days to get back to you with the details. The one thing that can't change much is the final RPM. When your swinging a 26' cabin cruiser onto land, it slow, steady, and easy. The davits pivot at about 1/2 RPM, and sometimes that seems fast.
This is an old and odd set up. This runs the power pivot on a 10K lb set of davits. A 1/2hp motor runs through a 60:1 reducer with a 6 pitch 7 tooth output pinion. The pinion turns a 58 tooth spur gear coupled to a 9 tooth 3/4 pitch chain sprocket that drives a 58 tooth chain sprocket on the...
I need to replace an odd gear and am having trouble finding a gear supplier. The pinion is a 6 pitch 7 tooth gear on the ouput shaft of a 60:1 reducer. I have tried a few suppliers, but no luck, so any suggestions would be appreciated.
Thanks.
You may want to look at this site, in particular Figure 10.
http://www.engr.ku.edu/~rhale/ae510/websites_f02/Manufacturing-tolerances.pdf
One other point, you mentioned specifying concentricity between two surfaces. If you are specifying a relationship between surfaces, you should use runout...
