I just recently upgraded from 2.008K to 2.009K. I looked to see if there was a different recommendation for the my Nvidia 1700 graphics driver than what I was using for 2008, and sure enough, there was. I guess one could feel safe in following the SW offically sanctioned driver...
oKay, Handleman said:
"There are two other ways I can think of immediately to get the end result of one line in the BOM:"
But what about the merits of my method? My method keeps the parts as an assembly without dumbing down, and it is a single entry in the BOM no matter how you set up the BOM...
I have modeled a sems screw (screw, lockwasher, flatwasher) by creating a derived part.
I put the screw, lw, & fw in one directory, and I put the derived part in that same directory.
Now when I insert it into an assy, there is a single part in the bom.
What are the pitfalls, if any, of using...
Does anyone know of a stock metal supplier that stock alum aly 5052-H32 in millimeter thicknesses (3, 4, 5 mm)? Metricmetals has the right thickness but not in 5052.
TIA
Dave
