You could also try breaking the associative like between the waved part & the parent model.
Double click the Linked Body in the Part Navigator.
Expand the WAVE Geometry Linker by selecting the down arrow at the bottom.
Expand the Settings box & uncheck the Associative tick box.
"It is...
I'm glad it solved your problem.
It will probably be easier to delete the existing table & reinsert it.
"It is impossible to make anything foolproof because fools are so ingenious."
Speaking under correction here but if I remember correctly, you can’t have a calculated value added as an expression.
So if you have a formula in the formula field of your expression it won't be allowed into a part family as it could create a circular reference.
Basically you will need to write...
The easiest way I found was to move the sketches first & then the curves.
Basicaly it works like this:
1. Show all Layers.
2. Find & move all sketches to layer X.
3. Hide layer X.
4. Find & move all curves to layer Y.
5. Hide layer Y.
"It is impossible to make anything foolproof because fools...
Cowski is right (as usual).
From personal experience, if you aren’t sweeping a round tube you need more than one guide curve.
"It is impossible to make anything foolproof because fools are so ingenious."
You must use the ADD NEWS SET button between selecting each set of curves.
Read the bottom of your screen carefully as it will guide you quite well.
I would also suggest that you use more than 1 guide curve to give you more predictable results.
See the attached file...
"It is impossible to...
Why don't you just change the reference set to solid or hid the layer that the datums are on?
"It is impossible to make anything foolproof because fools are so ingenious."
A method that I've used before is the following:
1. While in DRAFTING go to the MODEL (Ctrl+M).
2. Change your selection filter to FACE.
3. Orient the view with you mouse to close to the orientation you want & press F8 (The view will now be perpendicular to the selected face).
4. Now go...
All you PDF line width settings are in you Customer Defaults.
You'll find them in PDF Export under the Widths tab.
Also remember to check in both the Site & User defaults.
"It is impossible to make anything foolproof because fools are so ingenious."
Unfortunately I can't help you with that problem.
It actually goes one step further than that.
If you add a component to an assembly the new component will inherit the new line thickness settings but not the old ones.
What we've done as a workaround for the view issue is to go into the...
All you PDF line width settings are in you Customer Defaults.
You'll find them in PDF Export under the Widths tab.
Also remember to check in both the Site & User defaults.
"It is impossible to make anything foolproof because fools are so ingenious."
This may be a silly question but is snap to grid perhaps not switched on?
"It is impossible to make anything foolproof because fools are so ingenious."
Try changing the reference set of your part in the drawing to "entire part".
That's worked for me before.
"It is impossible to make anything foolproof because fools are so ingenious."
