Recent content by dkastz

hello colleagues, i am playing with MSC Adams machinery in order to learn it ...I have a example gear pair with shafts and "bearings". i have applied a torque and a "load" with user input mass Unfortunately i cannot retrive bearing forces... the values observed are not corresponding to...

...its like i have a sheet with complicated calculations of an angle. i want to have 100 increment input and see (and store)the result position...

Hello colleagues I have a range of cells with input data. For each of it i want to put corresponding value into a calculations sheet and store the result into new range - how to do that with VBA ? thanx and kind regards

hello i need to find reachable area of a mechanism, can you suggest me how

hello how can i find reachable area of a mechanism within RBD

hello again. please, answer me if you know i use ansys WB 16 and in rigid dynamics study i need to see mass center of an assembly thanx in advance

Hello, how can i see mass center in rigid body dynamics analysis tack

Hello colleagues. I have a system of rigid bodies and my goal is monitor joint forces. The hard part is how to redefine the mass center of the existing geometry ? If it was the mass only it can be done easy with creating material with the proper density, but here mass center coordinates are...

Hej! I think i have asked this before, but just to be sure: I want to assign buttons a s d w for PAN THE VIEWPORT respectively left down right up ? Is it possible anyhow tack !

mass and mass center distance to pivot are the same in both cases. only difference is in moments of inertia of the two bodies

haha i wish a homework, but I am 31 now... it is a simplification of a more complex problem, my worries were if differently distributed mass has different moment of inertia around given axis, therefore the load capacity is different... or all depends from mass center location

Dear friends I got stuck into simple crane problem, which deals moments and rotation around an axis. Imagine you have two “cranes” – with equal mass and similar dimensions W1 = W2 and L1 = L2, therefore only difference is in shape and thickness t1 and t2. Mass center of both is always in the...

okay people, this is simple: i must model the worm drive as it is - with proper teeth meshing, exact axes distance and proper rotation and so on... How this can be done ? Mates, physical dynamics and so on - please explain it hope the attached file is ok