Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by CameronA

  1. CameronA

    Adding .dxf to drawing view

    Hi all, I have a legacy sketch in autocad format that I need to add to a drawing view on an existing sheet in NX6. I have tried a few different ways and have not been able to make it work. I have tried the following processes with both .dxf and .cgm (imported the .dxf into a ne .prt and...
  2. CameronA

    Modeling in Assembly Environment

    I was able to use promote geometry to get what I needed. Thanks! Thanks again for the quick help guys. I've only been using NX for just over a year, hopefully I can contribute something here.
  3. CameronA

    Modeling in Assembly Environment

    I did create the new component using Assemblies>components>create new component I've begun modeling my new component and have it set as the "work part". When I have it set up this way I cannot select any geometry from the other components or create reference geometry (datums) using points from...
  4. CameronA

    Modeling in Assembly Environment

    I'm trying to create a new component within an assembly and I can't seem to extract geometry or reference any of the existing components. It seems that none of the features on existing components are select-able. What am I doing wrong? I'm sure there must be a way to do this. I am using...
See more

Part and Inventory Search

Back
Top