Hi! I have a 6ton hydraulic dennison gap frame multipress w. a 5hp motor. I am getting 3 phase power off a 15hp phase convertor. When I turn on the machine the ram goes down on the dieset and stops. It will not press. The pressure gauge stays zero. I turn the manual inching wheel and nothing...
Can somebody tell me why the upper plate on my die set does not move? It is a small 2 guidepost dieset. I want to make die blocks for it and stamp out parts. I know it is supposed to move up and down. But it wont. I dont see any bolts, valves, or anything.
