Recent content by Burnit

I apologise for the double post but after reading my first one correction was needed & i am unsure how to edit it. I require a constant flow of 12cu/mtrs of air per minute at 1.4bar & require help to calculate to power required to achieve this..

I need a discharge of 12cu/mtrs of air in 1 minute at a pressure of 1.4 bar, could someone assist me with the calulations to find to total power required in kW to achieve this. Cheers

Thanks Skogsgurra, That's what i thought.

Thanks waross, The Flyback voltage is of reverse polarity is it not?

Hello, When an Inductor is disconnected from a power supply does the magnetic field produced by it reverse in polarity like the voltage does? If so what Law describes this?

Thanks for the guide to some useable products, i will look into this. Yes, i agree that some soft types of metals may well be the way to go, it's the lubrication quality that has me stumped on this issue at the moment. I was thinking that soft seals may not be as abrasive as some metals on the...

Hi Pat, Temperature at the sealing surface i will try to keep as low as possible & i would think it will be around the 300 to 400 deg C hopefully less. The actual heat source temp will be higher but an attempt will be made to cool the sealing surface. At this stage the loading factor is an...

I am in the process of designing & machining an Alpha Stirling engine, as most are aware there is a HOT cylinder & a cold cylinder. My question is in regards to the hot cylinder & what suitable materials can be used for Cylinder Bores & Piston Rings or Seals with lubrication free operation...

I have an AC circuit that pulses a coil for an experiment, the circuit is sensitive to the inductance of the coil & has a small range in which it will work, outside & either side of this range it refuses to work. I want to increase the Flux density of the coil but working within this small...

It is the Pulse Induction Technology i am interested in & the Target Response Frequency as mentioned. Could not find any information on the particular subject at the link posted.

Hi All, Thought this may be the correct forum seeing it is to do with em waves. Firstly this is NOT homework etc but something i found on the internet that i need some help with. It is for the frequency response of subsurface metal targets. IE Metal Detectors etc. My take on this as with some...

Thank You Warpspeed, your post is very helpful! Thank You Again.

I am looking for a site or advice with the correct Inductance Calculations & Dimensions for the calculations for Random wound air coils. Do i use the same calculations as single layer spiral coils, there are many different inductance calculations for flat wound spiral, multilayer etc but i am...

I am looking for a site with the correct Inductance Calculations & Dimensions for the calculations for Random wound air coils. Do i use the same calculations as single layer spiral coils, there are many different inductance calculations for flat wound spiral, multilayer etc but i am unsure of...

I would like to setup a coil field examiner to test the strength of magnetic fields from metal detector coils. First up Is there a difference between AC & DC magnetic field detection equipment? What is the best cost effective method to do this simply, is there a simple circuit i can use to get...