There are lots of good guidelines to use for predicting volume change movements in large structures. Once a structure reaches a certain size, expansion joints are required becuase the stresses to restrain the thermal (creep, shrinkage) movements become excessive.
This is a major consideration...
Great post by Structuresareus. Just one oversight needs to be mentioned.
Any downward loading on the end walls should be tranfered into a footing and not into the slab unless you design the slab for this end load and resulting moment. If the downward load from the end walls is transfered into...
Agreed that it has been very interesting reading. It is difficult, however, (as is often is when attorneys are involved) to tell which side is actually telling the truth ... or reporting the full story.
It appears to me that the judges decision was dictated not by the facts of the case, but...
Just for completeness, let me add that the "slackness" issue with many threaded couplers (especially with load reversals) has not been addressed by any governing body. It is an area that needs some research to determine the "real world" affect on structures. The intuitive...
I haven't read much that I agree with yet.
Concrete is not designed with Limit State Design (LSD). It is designed with Ultimate Strength Design (USD). There is a huge difference. Steel LRFD is not a limit state design. LSD in steel is more like full plastic design. LSD in concrete is a...
You are correct. The amplification factor should be applied to the story shears. A response spectrum analysis would use a modal superposition to determine the forces. I believe the IBC will actually tell you that a response spectrum analysis should not be mixed with P-Delta amplification factors.
Several posters have nailed the purpose of the pad ... to avoid an end moment connection to the column.
I've investigated several failures where the end connection was designed as simply connected but erected with hard connections on top and bottom chords.
I've made it a practice to stop the...
You're about to make a HUGE mistake. TORQUE CANNOT be converted to TENSION. AISC allows erectors to callibrate torque to tension on an individual site basis and forces consistency with thread lubrication, etc. As soon as a change is made, the correlations are invalid.
I suggest you use the...
You need to talk to a geologist .... Preferably one who specializes in seismic records.
I've done this a few times myself, but always with factors provided by and derived by a geologist.
This applies to the site records, not the scaling factors. There are several good sources for the proper...
RiBeneke,
A Linton Threaded coupler is the only threaded coupler that does not have any "slack" in the threads because the threads are tappered ... similar to iron pipe threads. Any non-tappered threads will have some slack as a result of the tolerances required to thread a female...
Look them up in ACI 209 or any GOOD text book.
Good engineers realize these type calculations are only "order of magnitude" type calculations and adjust or tweek the equations to reflect the reality of their situation.
Type C fly ash is reactive and most common on in western us. It is more reactive than type F because type C has more free calcium ---- more alkalinity. Calcium hydroxide (lime) is a by product of cement hydration. Fly ash in the presence of free lime and moisture and alkalinity will hydrate...
Hooked bars have a clearly defined developement length per ACI-318. Additionally, hooked bars for shear purposed are considered "anchored" (ACI-318's word, not mine) when they are below a #5 and are bent around the flexural reinforcing. Does this mean they are fully developed? It is...
