I created this Upper Housing using the Shell feature and normal sweep options. I'd like some feedback on additional design approaches for the part - namely a design approach using "keep normal constant" in sweep options. Any additional design approaches would be much appreciated.
Attached is...
I'm presenting an introduction lecture of the analyses available in Solidworks + interference detection tomorrow morning.
If anyone could provide examples of the analyses that I could perform in class, I would greatly appreciate it.
TIA - battle
I should be obtaining a total of two faces after the split line feature with "Single Side" is completed on the attached part. However, the resulting feature has three faces. Please advise.
TIA - battle
I have read the help menu, and I just tried it on a part that is not symmetric with respect to the pattern, and I'm still unclear. I can see what's happening, but I don't understand.
Can someone state it explicitly,clearly?
I cannot find a satisfactory explanation of the difference between the Reference point options in the Sketch Driven Pattern Property Manager.
Centroid
Selected Point
Please explain. This is time sensitive, so a quick response will be greatly appreciated.
TIA,battle
I scaled and rotated the picture of the blade then traced it. The dimensions are not exact, but they are close. Hopefully close is sufficient for meeting manufacturing requirements.
Thanks, all!
Im having trouble designing this surgical blade to the specified dimensions. I tried importing the picture as a shetch and tracing the profile of the blade, but the image is 4:1 scale, so when I apply the correct dimensions the sketch blows up. Please advise.
I have another file that details...
