I'm looking for some casters that will lift a heavy piece of machinery off the ground momentarily to roll into a different location. I'm picturing a foot pedal, while using the wheel as a fulcrum to tilt each side of the machinery off the ground a very small amount. Similar to some of the...
Hello, I'm looking for a more efficient method to feed sample gas into our GC. Currently we capture gas using a vaccum tube which pulls gas into a bag, and then forced into the GC. I want shorten this procedure by a method that transports the gas directly from the collection point to the GC...
Yes, i should have mentioned that, male-male double ended, any type of high strength steel will do although preferably stainless, and I will be needing just 4. Thanks.
I've been searching for a bit now through industrial suppliers with no results. I need a threaded steel stud that can connect to two different thread sizes on its opposite end (5/8"-11 to 1/2"-13). I've found connectors and couplers but I would prefer a single piece of rigid metal. Perhaps...
