I have been having a problem trying to install 2007 and 2008 and having them both run.. The error I get is "Application Conflict' and I have to reload only one system.. Would like to work with 2008 but I still need 2007 to be my "Primary" application..
The detailed information that Im...
Running 2007 SW ( SP2)
I have noticed that when you have a "taped Hole" that it doesnt always simulate as such.
I have been going back and trying different options in the dialog and it does well for the drawing showing the minor and major diameter..
I have made sure that Annotations is...
OK so it was "Dynamic Highlighting" Getting closer..
It was a nice feature to use when you are moving around the part during the drawing detail.
Still dont have it turned on again but will respond back when i do. I'm surprised that those of you who detail prints havent been using it!!!
Hi Guys
In one of the previous releases, there was a red blinking dot that as you scrolled aroung the drawing would help keep you up to date as to what side of the datum you are on..
Im wondering if when detailing are there any automatic ways of having Solidworks confirm the datum selectionas...
