Recent content by altnickee

gurujeff33, You are correct I had to change all of them, but it worked!! thanks for the reply Toolmaker

JMirisola, Problem solved !! Thanks, Toolmaker

Hi, I have made a part on the top plane, but now i see that the front plane would be better. I know that there must be a way to change a part from an plane to an other, but how? thanks Toolmaker

problem solved!!! Thanks for the help Toolmaker

[b]altnickee[/v], Go to Tools > Options > System Options > General and select Auto-show PropertyManager.(setting are like above) cheers Toolmaker

I have 2008, I can't send bakc the file for you. Edit the first sketch, dim the arc, make both arcs equal.(done) Select the corner on the origin and remove the coincident.(done) Add a horiz centerline thru the center of the part mid-point to mid-point.(done) Make the mid-point of this line...

Riiiight, I had to add 2 centerline sketches( one horizontal & one vertical?) and add relations to the origin(yes, but how?), then remove the original relations of the sketches to the origin and add relations to the original sketch to the new centerlines using Symmetric relations. Catch all...

Hi, SW version 2007 in (extrude 1)I have a sketch in witch I want to relocate/move the origin from the left corner to the middle of the sketch. I first tried the following: Click Edit sketch/in the sketch I click on the origin, and (in the existing relation box) I selected the coincident o...

Thanks Chris, that did the job Toolmaker

Hi, I want to make an angled cutout in an assembly.(two parts) I have two cylindrical tubes concentric in an assembly that I want to cutout in an angle. Is there a way to make the cutout as you would do normally if these parts were one piece? Because of the angle it is hard to do it in the...

CorBlimeyLimey, Your tip did the job!!! thanks. Toolmaker

ctopher/MadMango Right-click on the surface, change color doesn’t work, so I made a Cut-extrude feature of my assembly. After this I tried to change to colors of the cut components, no problem changing the color of the parts in the assembly, but what I want to do,is to color the face that...

Hi , I have made a section view of a part, and I want to color the face of the section to show the section-cut more clearly. How to do this? Toolmaker

found on the internet size: 1 1/4 major dia: 1.250 tpi: 18 pitch dia: 1.2139 minor dia external(a): 1.1839 minor dia internal(b): 1.1899 Toolmaker

Tanks ctopher, But how can i obtain 1.250-18 UNEF thread specification, needed for setting the hole wizard settings? Toolmaker