Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by __Andy__

  1. A

    Adding load sense to a plain valve

    Thanks @FluidPowerUser ! Would the following scheme work? I would switch off the solenoid the instant the valve movement stops so the A/B lines don't bleed down through the orifice on the LS signal on the tractor. However if I then want to start movement again I would turn on the solenoid to...
  2. A

    Adding load sense to a plain valve

    I am thinking that my scheme will cause the pump to not see a difference in P and LS pressure. Therefore when I turn on the LS solenoid it will immediately ramp up to maximum pressure. Is that right? If so would I be better off connecting the solenoid and check valve to A/B? If so, how would I...
  3. A

    Adding load sense to a plain valve

    Hi, I am working on connecting a pair of closed-center proportional control valves in parallel to my tractor. The valves have P, T, A and B connections. The tractor has a closed center pressure-flow compensated system that has a load sense port. The pump has a max output of 25 GPM at 2,500 PSI...
See more

Part and Inventory Search

Back
Top Bottom