Creo/Elements Pro from PTC has stopped working

[kishorev]

Hello,

I created the pro/toolkit application in WF5.0 with 64bit,When i try to run with creo/elements,after running the cutom application for a while,it throws a meesage 'Creo/Elements pro from PTC has stopped working' and ask to clse the program in the middle.

Does any one come across such a issue and why does it occurs?

regards,
kishore

 

[hemuman]

Yes, this has happened several times. Reason is not known but sometimes it regains the control. Must be something to do with the Memory and Threads.

If you are doing a lot of calculation stuff and also using Creo 3D Graphics in background then do not be surprised with this message.

Hello,

I created the pro/toolkit application in WF5.0 with 64bit,When i try to run with creo/elements,after running the cutom application for a while,it throws a meesage 'Creo/Elements pro from PTC has stopped working' and ask to clse the program in the middle.

Does any one come across such a issue and why does it occurs?

regards,
kishore