Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastics Engineering general discussion

wgknestrick
  • Locked
  • Question Question
O-Ring Material for Molds
Replies
4
Views
570
Pud
Pud
twentyfiveover
  • Locked
  • Question Question
source for pigmented HDPE samples
Replies
3
Views
128
dwightdixon
dwightdixon
blueandwhiteg3
  • Locked
  • Question Question
Simple plastics modeling software
Replies
7
Views
189
NunoH
NunoH
cjcoop
  • Locked
  • Question Question
Material Foaming
Replies
11
Views
176
alpha0
alpha0
Dtuck
  • Locked
  • Question Question
TPE for decorated part
Replies
9
Views
210
patprimmer
patprimmer
cjcoop
  • Locked
  • Question Question
Delamination caused by shear heat
Replies
2
Views
128
cjcoop
cjcoop
glantman
  • Locked
  • Question Question
UV blocking resin
Replies
5
Views
227
sizzer33
sizzer33
jerzy
  • Locked
  • Question Question
Running ETFE in a hot runner mold.
Replies
0
Views
82
jerzy
jerzy
morphi
  • Locked
  • Question Question
Screw stoped when charging PMMA
Replies
5
Views
137
Pud
Pud
morphi
  • Locked
  • Question Question
Air trap in PMMA
Replies
12
Views
259
morphi
morphi
Demon3
  • Locked
  • Question Question
New Plastic that Changes Opacity - What is that effect called??
Replies
16
Views
505
HDS
HDS
chrisk123
  • Locked
  • Question Question
Vespel alternative - Meldin 7001
Replies
0
Views
199
chrisk123
chrisk123
mrlizzard
  • Locked
  • Question Question
vacuum formed plastic with gloss exterior
Replies
13
Views
349
patprimmer
patprimmer
whiv
  • Locked
  • Question Question
Wire holder molded into enclosure
Replies
1
Views
78
bvanhiel
bvanhiel
stanier
  • Locked
  • Question Question
Flexural Modulus PVDF to 50C and 25years
Replies
2
Views
123
ZiggyK
ZiggyK
mwalters
  • Locked
  • Question Question
Choosing a Chinese Mold builder
Replies
5
Views
169
jerrymould
jerrymould
Ian63
  • Locked
  • Question Question
Raw material cost - PP to PA66
Replies
7
Views
724
Ian63
Ian63
Chris1980
  • Locked
  • Question Question
Plastic/Steel Press Fit Interference
Replies
1
Views
63
patprimmer
patprimmer
Theophilus
  • Locked
  • Question Question
Blow molds with moving parts?
Replies
0
Views
130
Theophilus
Theophilus
snowrocka
  • Locked
  • Question Question
foam extrusion and mold?
Replies
4
Views
117
snowrocka
snowrocka
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top