Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gear and Pulley engineering

rgajewski
  • Locked
  • Question Question
BEST MATERIAL SPEC FOR ROLLERS
Replies
8
Views
269
mfgenggear
mfgenggear
InTheField
  • Locked
  • Question Question
Historical Data David Brown Gearbox?
Replies
5
Views
271
strokersix
strokersix
lumpyrugger
  • Locked
  • Question Question
Gear Terminology Question
Replies
5
Views
146
dinjin
dinjin
gdechaine
  • Locked
  • Question Question
Gear Train Alignment
Replies
12
Views
692
mfgenggear
mfgenggear
kubae
  • Locked
  • Question Question
powering a 20kw diesel engine using a system of gears driven by a 1.3
Replies
2
Views
135
Matt51
Matt51
npower0073
  • Locked
  • Question Question
Gearbox oil decreasing pressure during summer
Replies
2
Views
184
diskullman
diskullman
Tmoose
  • Locked
  • Question Question
gearbox acceptance tests and quality certs
Replies
3
Views
218
tbuelna
tbuelna
cdeane44
  • Locked
  • Question Question
Too much backlash between gears
Replies
11
Views
799
eromlignod
eromlignod
jgatlin
  • Locked
  • Question Question
Calculating Simpson Compound Planetary Ratio
Replies
7
Views
889
Matt51
Matt51
robojerry
  • Locked
  • Question Question
aluminum gears and coatings
Replies
5
Views
442
unclesyd
unclesyd
Tmoose
  • Locked
  • Question Question
Klingelnberg gear advantages
Replies
1
Views
418
Matt51
Matt51
anticz
  • Locked
  • Question Question
What's the formula for planet RPM in an epicyclic gear.
Replies
2
Views
544
anticz
anticz
Trukker
  • Locked
  • Question Question
Worm tooth angle
Replies
2
Views
147
Trukker
Trukker
ZCHSC
  • Locked
  • Question Question
Meshing Dissimilar Pressure Angles
2
Replies
21
Views
1K
mfgenggear
mfgenggear
luky
  • Locked
  • Question Question
AGMA2015/915-1-A02
Replies
2
Views
115
Tmoose
Tmoose
rharr
  • Locked
  • Question Question
DIN 5480 Spline Tolerance
Replies
4
Views
675
spigor
spigor
solidNeutron
  • Locked
  • Question Question
An anti-backlash gear with module 3
Replies
3
Views
170
Pekelder
Pekelder
gearcutter
  • Locked
  • Question Question
Load distribution of DC motors.
Replies
4
Views
220
sreid
sreid
mclearg
  • Locked
  • Question Question
Worm drives - rubbing speeds etc
Replies
1
Views
140
BobM3
BobM3
borjame
  • Locked
  • Question Question
Internal/external spline definition
Replies
2
Views
226
gearcutter
gearcutter
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top