Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

amitpaul713
  • Locked
  • Question Question
Need help on Tolerance stackup
Replies
10
Views
502
JNieman
JNieman
iamerror
  • Locked
  • Question Question
Drafting Compound Angles
Replies
9
Views
576
iamerror
iamerror
natepiercy
  • Locked
  • Question Question
Aligning center of hole with center of triangluar feature
Replies
4
Views
336
DeanAllen
DeanAllen
hobbs101
  • Locked
  • Question Question
GD&T for centreline positioning?
2
Replies
22
Views
1K
DeanAllen
DeanAllen
AndrewTT
  • Locked
  • Question Question
new question on figure 7-45
Replies
4
Views
141
mkcski
mkcski
JaPaBo
  • Locked
  • Question Question
Heatsink Flatness Specification
Replies
5
Views
576
JaPaBo
JaPaBo
AndrewTT
  • Locked
  • Question Question
2009 standard - figure 7-45 ???
Replies
6
Views
111
mkcski
mkcski
amitpaul713
  • Locked
  • Question Question
Statistical Tolerance
Replies
4
Views
247
3DDave
3DDave
mdambros
  • Locked
  • Question Question
To part mark, or not to part mark
Replies
12
Views
573
KENAT
KENAT
filippoGDeT
  • Locked
  • Question Question
Two Holes as Datum Feature - Complex Die Cast Dimensioning strategy
Replies
6
Views
399
3DDave
3DDave
abrewmaster
  • Locked
  • Question Question
Create Centerline Datum From Drafted Faces
Replies
2
Views
391
3DDave
3DDave
agreenman
  • Locked
  • Question Question
T/S Drawing Abbreviation
Replies
4
Views
871
agreenman
agreenman
artnmotion
  • Locked
  • Question Question
Surface Finish - Assy Title Block
Replies
9
Views
1K
sammcc
sammcc
Oaklandishh
  • Locked
  • Question Question
Keep axis parallel and in same plane with GDT?
Replies
10
Views
740
pylfrm
pylfrm
JBATX
  • Locked
  • Question Question
Attach surface profile FCF to feature of size dimension?
Replies
18
Views
899
pylfrm
pylfrm
cbrf23
  • Locked
  • Question Question
Continuous feature distinction between similar features (Y14.5-2009)
Replies
7
Views
2K
pylfrm
pylfrm
BHACHU
  • Locked
  • Question Question
CUSTOM FRAME FOR TEXT IN CATIA V5 DRAWING
Replies
2
Views
257
BHACHU
BHACHU
appvid
  • Locked
  • Question Question
wire harness drawings standard
Replies
3
Views
497
appvid
appvid
Ksplice
  • Locked
  • Question Question
True Position Gage for feature without MMC
Replies
6
Views
740
3DDave
3DDave
catiaUSR
  • Locked
  • Question Question
GD&T Clocking of Hex Cut-Out
Replies
5
Views
284
catiaUSR
catiaUSR
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top