Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

gabimo
  • Locked
  • Question Question
Difference between algorithms
Replies
4
Views
859
axym
axym
aniiben
  • Locked
  • Question Question
Mathematical definition: multiple datum feature-primary on a cylindrical surfaces
Replies
8
Views
156
aniiben
aniiben
pyromech
  • Locked
  • Question Question
Flatness control
Replies
10
Views
301
CheckerHater
CheckerHater
SMO
  • Locked
  • Question Question
Runout only used for parts that rotate in their assembly?
2
Replies
22
Views
925
SMO
SMO
SMO
  • Locked
  • Question Question
Good ASME Y14... Standards to Have?
Replies
5
Views
285
SMO
SMO
greenimi
  • Locked
  • Question Question
Y14.41 approach
Replies
3
Views
289
aniiben
aniiben
Bishbosh
  • Locked
  • Question Question
Continuous Feature
Replies
1
Views
192
Belanger
Belanger
AndrewTT
  • Locked
  • Question Question
extension of principles - composite profile (non-uniform)
Replies
9
Views
279
AndrewTT
AndrewTT
Euan Foster
  • Locked
  • Question Question
Critical, Major and Minor Dimensions
Replies
5
Views
3K
3DDave
3DDave
AndrewTT
  • Locked
  • Question Question
Y14.5-2009, figure 5-13 & 5-14
Replies
5
Views
167
powerhound
powerhound
Barnon
  • Locked
  • Question Question
Is Datum B understood to be a centerline?
2
Replies
20
Views
1K
mkcski
mkcski
pyromech
  • Locked
  • Question Question
Combinations & Permutations for gd-t
Replies
3
Views
139
drawoh
drawoh
alkung
  • Locked
  • Question Question
True position of a hex center?
Replies
18
Views
1K
SwinnyGG
SwinnyGG
JonSelby
  • Locked
  • Question Question
Reference Dimension: Diameter In or Out?
Replies
7
Views
2K
looslib
looslib
RLD89
  • Locked
  • Question Question
Multi-single segment profile (or positional) tolerance defined as datum
Replies
2
Views
123
3DDave
3DDave
gabimo
  • Locked
  • Question Question
Old article --rule#1 expanded to irregular features of size...not sure I agree
Replies
6
Views
358
greenimi
greenimi
fishchoke
  • Locked
  • Question Question
Using True Position Tolerance In Lieu of Profile?
Replies
5
Views
732
fishchoke
fishchoke
AndrewTT
  • Locked
  • Question Question
fixed fastener calculation
2
Replies
22
Views
2K
JNieman
JNieman
greg2835
  • Locked
  • Question Question
locating hole from a different plane
Replies
15
Views
702
mkcski
mkcski
koalabjj
  • Locked
  • Question Question
Inside Bend Radius Call Outs
Replies
7
Views
1K
drawoh
drawoh
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top