Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

cadfreak
  • Locked
  • Question Question
General notes for a Socket Set Screw Dog Point?
Replies
3
Views
212
CoryPad
CoryPad
cadfreak
  • Locked
  • Question Question
Drafting Standards Quick Reference...
Replies
2
Views
175
Heckler
Heckler
smcadman
  • Locked
  • Question Question
Offset Section View jog lines
Replies
3
Views
170
Heckler
Heckler
castermaster
  • Locked
  • Question Question
Does a centerline datum follow a deflected shape?
Replies
4
Views
197
caseynick
caseynick
scotty7
  • Locked
  • Question Question
What Drafting Standards do International Companies Use?
Replies
10
Views
784
castermaster
castermaster
KimBellingrath
  • Locked
  • Question Question
countersink callout
Replies
16
Views
1K
ewh
ewh
debodine
  • Locked
  • Question Question
Drawing Requirements Manual
Replies
6
Views
446
Tunalover
Tunalover
Runz
  • Locked
  • Question Question
How does Rule #1 apply to 2 holes...
Replies
12
Views
469
ewh
ewh
ant77
  • Locked
  • Question Question
E-clips on centered shaft
Replies
11
Views
338
ant77
ant77
Runz
  • Locked
  • Question Question
Angular (Timing) orientation of 2 different patterns?
Replies
9
Views
314
drawoh
drawoh
chevy1000
  • Locked
  • Question Question
Dimensioning a surface from 4 inline holes.
Replies
2
Views
199
ewh
ewh
spacemonkey3D
  • Locked
  • Question Question
Drawing Requirments Manual?
Replies
3
Views
163
debodine
debodine
terbo29
  • Locked
  • Question Question
Location information for Hole Position Relative to Basics
Replies
5
Views
218
drawoh
drawoh
zora65
  • Locked
  • Question Question
Blended Radius
Replies
2
Views
589
ctopher
ctopher
Runz
  • Locked
  • Question Question
Datum call-out on tangency of two radii...
Replies
2
Views
154
AliThePro
AliThePro
whotmewory
  • Locked
  • Question Question
GD&T for controlling excessive "twist."
Replies
15
Views
713
dingy2
dingy2
thundair
  • Locked
  • Question Question
ANSI Y14.5
Replies
8
Views
290
thundair
thundair
Tunalover
  • Locked
  • Question Question
Where are the machine shops that REALLY know GD&T?
Replies
4
Views
194
Heckler
Heckler
ye368
  • Locked
  • Question Question
datum target areas
Replies
3
Views
566
dingy2
dingy2
Pevac
  • Locked
  • Question Question
Attaching Geometric Tolerance frame to a surface?
Replies
15
Views
442
dingy2
dingy2
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top