Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ligo
  • Locked
  • Question Question
Rotational orientation on circular parts with cylindrical Datum
2
Replies
30
Views
985
SeasonLee
SeasonLee
prdave00
  • Locked
  • Question Question
Proper GD&T on sliding "piston" assembly
Replies
19
Views
375
prdave00
prdave00
fsincox
  • Locked
  • Question Question
Limits on the applicability of cylindrical zones
Replies
18
Views
280
fsincox
fsincox
BridgeNut
  • Locked
  • Question Question
Symmetry Annotation
Replies
6
Views
459
KENAT
KENAT
ozzkoz
  • Locked
  • Question Question
TIR and ruout or total runout
2 3
Replies
46
Views
2K
fsincox
fsincox
BluTurtle
  • Locked
  • Question Question
profile tolerance
Replies
18
Views
418
MechNorth
MechNorth
twkinfected
  • Locked
  • Question Question
Bend Radius Tolerance
Replies
7
Views
312
KENAT
KENAT
SDETERS
  • Locked
  • Question Question
Limited Length 1.7.3 ASME Y14.5 M-1994
Replies
17
Views
383
fsincox
fsincox
Belanger
  • Locked
  • Question Question
Runout includes profile?
2 3
Replies
41
Views
1K
fsincox
fsincox
ctopher
  • Locked
  • Helpful tip Helpful tip
GD&T doc
2
Replies
20
Views
805
fsincox
fsincox
turboanden
  • Locked
  • Question Question
basic dimension
Replies
14
Views
522
fsincox
fsincox
andymat
  • Locked
  • Question Question
Parallel coincident faces
Replies
14
Views
1K
fsincox
fsincox
cwdaniel
  • Locked
  • Question Question
Basic locating angle without FCF, yes/no?
2
Replies
29
Views
458
fsincox
fsincox
Daekar
  • Locked
  • Question Question
Tertiary Datums and Bolt Circles
2 3
Replies
49
Views
1K
Belanger
Belanger
BluTurtle
  • Locked
  • Question Question
Question about dates on title block
Replies
16
Views
949
drawoh
drawoh
twkinfected
  • Locked
  • Question Question
Hole position w/ concentric radius
Replies
13
Views
446
gadkinsj
gadkinsj
ewh
  • Locked
  • Question Question
Expert Opinion on Section Views Needed
Replies
8
Views
129
looslib
looslib
njw5
  • Locked
  • Question Question
3D Point Tolerance on Part - Car Body Position
Replies
2
Views
131
HGMorgan
HGMorgan
rupeshpahwa
  • Locked
  • Question Question
Standard thread 3/4 -16 UNF
Replies
7
Views
371
juergenwt
juergenwt
YCENG
  • Locked
  • Question Question
BEST METHOD FOR SMALL, TIGHT TOLERANCE, HOLES
Replies
7
Views
209
ewh
ewh
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top