Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

LITTLEMAN3
  • Locked
  • Question
Datum with flatness and position tolerance specified?
Replies
8
Views
221
drawoh
drawoh
SDETERS
  • Locked
  • Question
Angle Less than One Degree. 4
2
Replies
25
Views
699
KENAT
KENAT
ryandias
  • Locked
  • Question
Question on Surface Roughness Callout 1
Replies
9
Views
256
321GO
321GO
aeroengr
  • Locked
  • Question
GD&T Varying Tolerance Control Over Flat Surface 1
Replies
2
Views
113
pmarc
pmarc
Dave K
  • Locked
  • Question
FWD to the left? (automotive) 1
Replies
6
Views
257
Dave K
Dave K
davidrdguez
  • Locked
  • Question
Positioning pins 1
Replies
8
Views
433
KENAT
KENAT
fcsuper
  • Locked
  • Question
Mythical non-accumulative tol callout on patterns
Replies
8
Views
477
carnage3
carnage3
philipdmartin
  • Locked
  • Question
Drawing Types (e.g. casting vs. machined vs. assembly.... 1
2
Replies
24
Views
906
SDETERS
SDETERS
ligo
  • Locked
  • Question
Datum use with a pattern of a pattern?
2
Replies
25
Views
387
ligo
ligo
acnme
  • Locked
  • Question
simulating datum target area on cmm 1
2
Replies
29
Views
1K
DeanD3W
DeanD3W
ryandias
  • Locked
  • Question
Basic Dimensions
Replies
6
Views
147
SteveMartin
SteveMartin
ozzy1
  • Locked
  • Question
tolerancing for draft 1
Replies
6
Views
194
fcsuper
fcsuper
evolDiesel
  • Locked
  • Question
Inspection Dimension (SolidWorks drawings) 6
2
Replies
39
Views
3K
DeanD3W
DeanD3W
REDesigner09
  • Locked
  • Question
GD & T Fonts for Excel or Word
Replies
7
Views
740
ozzy1
ozzy1
PobbeS
  • Locked
  • Question
Positional tolerancing and implied symmetry 1
2
Replies
23
Views
458
Belanger
Belanger
fsincox
  • Locked
  • Question
MIL Spec Revisions
Replies
5
Views
532
ptruitt
ptruitt
acnme
  • Locked
  • Question
inspection gage for boss true position
Replies
3
Views
229
dingy2
dingy2
TeejT
  • Locked
  • Question
Weld symbol for perimeter weld of nut/threaded rod interface
Replies
5
Views
376
MintJulep
M
BiPolarMoment
  • Locked
  • Question
Coaxial Cylinder Weld Symbols
Replies
7
Views
278
BiPolarMoment
BiPolarMoment
buchner
  • Locked
  • Question
Can I relate a hole pattern to be parallel and/or perpendicular only?
Replies
5
Views
266
pmarc
pmarc
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom