Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

STLinjunear
  • Locked
  • Question Question
Automotive industry standard for numbering mirror image parts?
Replies
8
Views
476
ptruitt
ptruitt
SpaciouS
  • Locked
  • Question Question
Profile vs Parallel & Perpendicular
2
Replies
21
Views
914
fsincox
fsincox
pmarc
  • Locked
  • Question Question
Tolerance Stack Question
2
Replies
27
Views
628
Belanger
Belanger
DaSalo
  • Locked
  • Question Question
Airfoil profile inspection
Replies
6
Views
483
MikeHalloran
MikeHalloran
Madhu454
  • Locked
  • Question Question
Guage design to varify parts with L modifiers
Replies
13
Views
237
DeanD3W
DeanD3W
courtjester140
  • Locked
  • Question Question
"Per Unit Basis" For Roundness?
2
Replies
35
Views
447
SeasonLee
SeasonLee
roberto1brazil
  • Locked
  • Question Question
CMM_Best Fit_Group of pins as datum
Replies
7
Views
332
roberto1brazil
roberto1brazil
ptruitt
  • Locked
  • Question Question
Position Bonus/MMC, Cpk, and Inspection Results, Nominal Geometry
2
Replies
24
Views
1K
ptruitt
ptruitt
Madhu454
  • Locked
  • Question Question
Use of M modifiers on threded faetures
Replies
11
Views
512
Belanger
Belanger
Madhu454
  • Locked
  • Question Question
Threaded features as Datum's
Replies
2
Views
1K
drawoh
drawoh
bpcash
  • Locked
  • Question Question
Document Tight Tolerances
Replies
19
Views
447
fcsuper
fcsuper
Madhu454
  • Locked
  • Question Question
Use of M modifier for interference fits?
Replies
8
Views
372
PaulJackson
PaulJackson
PeteratPSP
  • Locked
  • Question Question
ITAR verses AS9100
Replies
5
Views
303
SCBTCI
SCBTCI
PeteratPSP
  • Locked
  • Question Question
What is "No Chamfer"
2
Replies
24
Views
1K
fcsuper
fcsuper
Madhu454
  • Locked
  • Question Question
Runout
Replies
8
Views
291
pmarc
pmarc
Madhu454
  • Locked
  • Question Question
Flatness V/S Taper
Replies
12
Views
381
powerhound
powerhound
Madhu454
  • Locked
  • Question Question
Preparation for GDTP Technologist certification exam
Replies
5
Views
406
Madhu454
Madhu454
swforge1
  • Locked
  • Question Question
casting datums
Replies
7
Views
496
DeanD3W
DeanD3W
prdave00
  • Locked
  • Question Question
Datum shift + Stack-Up
2
Replies
21
Views
1K
prdave00
prdave00
LizardmanDan
  • Locked
  • Question Question
IUID Note on Drawing
Replies
0
Views
182
LizardmanDan
LizardmanDan
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top