Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

plastics - and UV testing

Status
Not open for further replies.
DRahe

DRahe

Industrial
Jul 26, 1999
4
I am looking for insight into what UV standards are typically used for plastics. Is ASTM most frequently used? what about IEC? also I understand that the IEC requires more broadband frequency range. Any comments would be appreciated.

 
Replies continue below

Recommended for you

Sort by date Sort by votes
I'm not sure about industrial designs but most of the architects prefer ASTM and BS in terms of UV testing.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

innominata
  • Locked
  • Question
Face Seal Fastener Placement and Spacing 3
Replies
6
Views
1K
DogPAnt
DogPAnt
DogPAnt
  • Locked
  • Question
Water sealing problem with epoxy and PVC
Replies
5
Views
690
DogPAnt
DogPAnt
Azeen
  • Locked
  • Question
Mixing virgin and recycled Polypropylene Granules in single use plastic straw extrusion machine
Replies
5
Views
819
Linda0510
Linda0510
andradesilva
  • Locked
  • Question
differences between 3D printing a part in metal and in polymer
Replies
2
Views
312
IRstuff
IRstuff
QualityTime
  • Locked
  • Question
Pyrolysis of Contaminated Waste Thin Film Plastics to Char
2 3
Replies
44
Views
840
MacGyverS2000
MacGyverS2000

Part and Inventory Search

Sponsor

Back
Top Bottom