Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pre-heat for Naphtha Units

Status
Not open for further replies.

sharpey33

Chemical
Feb 5, 2003
1
Hello all.
We are exploring changing the pre-heat to our NHT and catalytic reformer to a welded plate heat exchanger (Packinox).
I wanted to see if anyone had any bad experience with these, in this type of service.
The manufacture tells us that we can easily improve out hot-end approach temperature by 60-70 F.

thanks
A. Sharpe
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor