I am looking for a method to detect location or proper loading of a part in a rotating chuck prior to machining, NOT just presence. Interested in something simple that could be installed with the least amount of retrofitting required to the existing fixtures. It could either be pneumatic or electronic with an accuracy of ±.001". Thank you in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Part Location Verification
- Thread starter AMV
- Start date
Similar threads
- Locked
- Question
- Locked
- Question