Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

90° Elbow Dimensions

Status
Not open for further replies.

Zimmy242

Industrial
Joined
Apr 19, 2023
Messages
6
Location
US
I am trying to figure out the lengths of R3 (Spine length), R2 (Center Length), and R1 (Throat Length). I know that D1 equals 6" and that the Center Line Radius is 1.5 x D1. I also know that T1 and T2 are both 9" (I don't think these matter though). Can anyone help me? I'm trying to make an excel that will allow me to change the diameter and CLR and give me R3, R2, and R1.
Elbow_Pic._yktwik.png
 
"Length" I assume you mean circumference?

So L= Pi x (2x R1,2 or 3) x 90/360

Where your angle is 90 degrees.

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Bless your for trying. If you have a contact for sheet metal supplier or a contractor go visit them and see what is sold and installed in your area. I tried the same thing, then reality slapped me the face.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top