Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mode Steps problem

Status
Not open for further replies.

S1mul4t0r101

Student
Mar 7, 2023
17
Hello.

I am running modal analysis on ABAQUS on a disk with damping materials on it but I keep getting modes that are 0.01 Hz frequency apart. Can anyone tell me what can be changed in the modal analysis step so that it ignores such modes and takes larger steps?
Here are the modal step and the results that I get.
Screenshot_2_yjoz2c.png
Screenshot_1_jsgcsn.png
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor