Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HybridShapeFactory.AddNewSweepExplicit GuideCurveAnchors ?

Status
Not open for further replies.

PeterGuy

Automotive
Joined
Jan 15, 2003
Messages
249
Location
GB
Hi
Does any one know the commands required to add the Guide Curve Anchors when generating a surface with two guide curves? I strongly suspect it is burried in the methods that define the profile axis plane & the sweep plane but I have as yet not been able to fathom it out.


Many thanks

Pete

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top