Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
HELP!! Need to change sketch support using a VBscript macro
- Thread starter faskis
- Start date
You will probably need to set a new absolute axis for the sketch. This can be obtained by using the selected element get Coordinates and click twice in different areas on the face and create the plane matrix from that. If you did not do it interactively then you could calculate the new coordinates if it was a pad from Limit2 depth and a vector direction.
Greg
Greg
- Status
Similar threads
