Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolanalyst

Status
Not open for further replies.
moon161

moon161

Mechanical
Joined
Dec 15, 2007
Messages
1,184
Location
US
Is anyone familiar with the SWX Tolanalyst?

I want to do a stackup study with a pump assembly and I'm curious how it works with multiple supports on a bar (shaft in this case)
 
Sort by date Sort by votes
I never got a chance to use it--when I asked Dassault if it could handle GD&T (A decade ago) the answer was 'no' so it would have been of limited use anyway.
 
Upvote 0 Downvote
There are tolanalyst tutorials in solidworks. I think the two main steps are to define datums and gd&t in dimxpert, and then define the assy sequence. Best part is it will generate a report. Good luck
 
Upvote 0 Downvote
Thanks! I have gotten to using it a bit.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

321GO
  • Locked
  • Question Question
TolAnalyst struggle
Replies
0
Views
159
321GO
321GO
markbreneman
  • Locked
  • Question Question
Tolanalyst
Replies
0
Views
117
markbreneman
markbreneman
hotiron
  • Locked
  • Question Question
Tolanalyst
Replies
8
Views
389
uGlay
uGlay

Part and Inventory Search

Sponsor

Back
Top