Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface to surface radiation

Status
Not open for further replies.
In 2D steady state analysis in Workbench, anyone knows why Ansys create additional elements when you apply a heat flux or heat flow in a line?

Ansys creates this new element and after this gives error in the solution because creates a four node element with a non-existing node...
 
I already fixed it.
I am using static thermal analysis and the error was coming from the keyopt options of the surface elements.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top