Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to apply Accelerations?

Status
Not open for further replies.
flyforever85

flyforever85

New member
Joined
Jun 22, 2010
Messages
178
Location
US
Hi,
never used accelerations before in Hypermesh. I have the full mode of an helicopter with some masses attached with RBEs. I want to apply ANGULAR accelerations to the CG and run an inertia relief analysis. Any way to do it? I also have the relative inertia factors (the "g"). Can't use GRAV card of course
 
Status
Not open for further replies.

Similar threads

Nir_k
  • Locked
  • Question Question
How to select both the exterior and interior surfaces (All Entities) of an element when creating surfaces in Hypermesh?
Replies
0
Views
2K
Nir_k
Nir_k
Behdad.S
  • Locked
  • Question Question
How do separate parts that share some same nodes?
Replies
2
Views
809
Behdad.S
Behdad.S
Max121
  • Locked
  • Question Question
"Exporting mesh hypermesh to ansys
Replies
0
Views
723
Max121
Max121
Nuaaer
  • Locked
  • Question Question
Use RBE3 to connect Conm2
Replies
0
Views
709
Nuaaer
Nuaaer
flyforever85
  • Locked
  • Question Question
How can I keep the same Components in Hypermesh and Hyperview
Replies
0
Views
658
flyforever85
flyforever85

Part and Inventory Search

Sponsor

Back
Top