Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to setup a Moldex3D project for optimization with external software

Status
Not open for further replies.
andradesilva

andradesilva

Materials
Joined
Jun 20, 2017
Messages
125
Location
PT
Hello!

I am simulating the injection moulding process with Moldex3D. I would like to run design optimization in the geometry of my mould by coupling my simulation/model with external software, such as MATLAB or Fortran. Does anyone know how to setup my Moldex3D project?

Best regards,
Andrade Silva
 
Status
Not open for further replies.

Similar threads

enginesrus
  • Locked
  • Question Question
Adhesive for Polyethylene to Stainless steel
Replies
2
Views
3K
TugboatEng
TugboatEng
MechMatengineer
  • Locked
  • Question Question
Quality control for plastic piping
Replies
1
Views
3K
Pud
Pud
Buckshott00
  • Locked
  • Question Question
Process Setting for Improved Over-molding to prevent delamination In Molded Hytrel
Replies
0
Views
959
Buckshott00
Buckshott00
rollingcloud
  • Locked
  • Question Question
[CIE76] How much of delta-E does this represent?
Replies
7
Views
1K
IRstuff
IRstuff
clyde Verse
  • Locked
  • Question Question
Any way to produce a 100% same plastic lampshell without injection mold?
Replies
5
Views
1K
Pud
Pud

Part and Inventory Search

Sponsor

Back
Top