Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pop up error message sying this not the fault of your model

Status
Not open for further replies.

masterymw

Automotive
Joined
Aug 7, 2020
Messages
26
Location
NP
When the model is going to big ( in which synchronous ac motor is used), I get the error message saying that "Adams has stopped working exported. This is a fault of the software, not your model................"
I don't know what is the solution to avoid it.
errormsg_pvaagy.png
 
I had asked in the MSC ADAMS forum as you suggest. I came to know that my bin file was corrupt due to repeated saving of bin file at the same files. So once I began to save it at a different file, it worked.
Just sharing what I found!
Many Many thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top