Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ATEX multiple circuits / one breaker

Status
Not open for further replies.

escapadro

Electrical
Joined
Oct 4, 2017
Messages
13
Location
DK
Hi there,

I am wondering, what are the constraints on supplying a number of loads in the same ATEX zone with one breaker feed and daisy-chaining them? The supply is 230V, but the load demand is very small so we were hoping to link these devices and put them all on one circuit.

Is this feasible? I am not sure on what ATEX Directive states regarding this.

Any help will be appreciated!

Regards

escapadro
 
It may be helpful to include a little more information.
Your answer is somewhat code specific.
This is an international forum.
Code constraints vary from place to place.

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
The ATEX Directive consists of two EU directives specifying minimum protection criteria for the workplace and equipment used in explosive atmospheres.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top