bobthebuilder000
Industrial
Can polycarbonate be used for screwdriver handle?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Polycarbonate for screwdriver handle
- Thread starter bobthebuilder000
- Start date
- Status
MacGyverS2000
Electrical
Anything reasonably solid can be used for a screwdriver handle... even a bundle of duct tape.
Dan - Owner
Dan - Owner
The go-to material is cellulose acetate:
While polycarbonate can used, if you are doing this for a product, why change? Your material of choice has to conform to customer expectations for look and feel, wear, chemical resistance, surface damage, etc.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
While polycarbonate can used, if you are doing this for a product, why change? Your material of choice has to conform to customer expectations for look and feel, wear, chemical resistance, surface damage, etc.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
MikeHalloran
Mechanical
Speaking of chemical resistance, polycarbonate basically has none.
Mike Halloran
Corinth, NY, USA
Mike Halloran
Corinth, NY, USA
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question