Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AS 1553 / AS 2203.1 (filler material standard) 1990 edition someone? 1

Status
Not open for further replies.

kingnero

Mechanical
Joined
Aug 15, 2009
Messages
1,783
Location
BE
Could someone please tell me what the requirements are for yield and tensile strength according to the below specifications please?
I would really appreciate a screenshot from the relevant table or something similar (but I will take whatever I can get!).
Thanks for your kind cooperation...

AS 2203.1 - 1990 : ETD-GXp-W769A.K4

AS 1553 (no version mentioned but an edition of similar age) : E4818 or E4816
 
Sorry can't help with screenshot but here is some info.

For your FCAW
Tensile = 760 - 900 Mpa
Min yield = 680 Mpa
Min elongation = 14%
Min impact values (average) = 27j@ - 50 degrees C

For your MMAW
Tensile = 500 - 620 Mpa
Min yield = 420 Mpa
Min elongation = 22%

There is a note for the MMAW
For each increase of 1% in the value of elongation over the minimum a decrease of 10 Mpa in Tensile and Yield strength is allowed to the following minimum values
Tensile = 480 Mpa
Yield = 400 Mpa

Hope that helps,
Cheers,
Shane
 
Thank you very much!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top