TOLERANCE ANALYSIS
TOLERANCE ANALYSIS
(OP)
Hello everyone.
I'm working on Inventor (I know the forum is not for this software but it is for Autodesk)
I wanted to know if any of you know how I can select this face to generate this gap in the tolerance analysis environment
Left is my reality, right is my expectation
I'm working on Inventor (I know the forum is not for this software but it is for Autodesk)
I wanted to know if any of you know how I can select this face to generate this gap in the tolerance analysis environment
Left is my reality, right is my expectation

RE: TOLERANCE ANALYSIS
Click here: forum790: Autodesk: Inventor
Copy-paste your question, then red-flag this one. It won't be held against you; just make sure to check in the future.
www.sparweb.ca