Heating foil simulation
Heating foil simulation
(OP)
Hi people.
I want to simulate time dependent heating up of a following setup:
-heating foil (200W)surrounded by two plates of same area
-upper plate is insulation:
k=0,035W/mK
width=0,2m
-bottom plate is clay:
k=1W/mK
width=0,05m
I would like to find out how to reach stationary state. In particular I would like to know, if the heat flux in both directions is constant and same as in stationary state?
I want to simulate time dependent heating up of a following setup:
-heating foil (200W)surrounded by two plates of same area
-upper plate is insulation:
k=0,035W/mK
width=0,2m
-bottom plate is clay:
k=1W/mK
width=0,05m
I would like to find out how to reach stationary state. In particular I would like to know, if the heat flux in both directions is constant and same as in stationary state?
RE: Heating foil simulation
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! https://www.youtube.com/watch?v=BKorP55Aqvg
FAQ731-376: Eng-Tips.com Forum Policies forum1529: Translation Assistance for Engineers Entire Forum list http://www.eng-tips.com/forumlist.cfm