Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Design procedure of cast elbows and returnbends

Status
Not open for further replies.

Yuger_ser

Petroleum
Joined
Nov 27, 2019
Messages
2
Location
RU
Hello!

In designing coils for petroleum heates and usualy use API 530. API 530 said that cast componets are not covered by this standard. In API 560 i didn't find information about cast components desinging. I know that difference between steel returnbends and cast returnbends is in wall thickness in intradoss and estradoss, steel returnbends according to API 530 has thick wall in intradoss and thin wall in estradoss against cast returnbends. Where can i find design equation for cast componets? Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top