I have taken my loads out of a RISA 3D model to analyze a small section of the model using Solidworks simulation. I am getting very large displacement and it seems to be an issue with the pins. Has anyone else seen this issue?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pin Connection Issues
- Thread starter massnub
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question