Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inputting a particular value of frequency and getting distance-dependent output images of the model

Status
Not open for further replies.

Sanjay ravi

Materials
Joined
Aug 6, 2019
Messages
1
Location
US
Dear fellow scientists,
I am working on a project which is in correlation with acoustic imaging using ABAQUS. I am having trouble inputting a particular value of frequency in the frequency domain step in ABAQUS. The input frequency should be impinged on one side of the model and I need to get results for that particular value of frequency at different distances from the outer side of the material using ABAQUS. I have attached the model for your reference.
 
By frequency domain I guess you mean steady-state dynamics step, right ? In the step definition of this analysis you specify the frequency of harmonic excitation. You can either give a single value or a range of frequencies. In the latter case Abaqus produces results for several different frequencies from the specified range. However this is the global setting for whole model and all harmonic loads.

There's no file attached, please try to post it again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top