Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

L114 Tube

Status
Not open for further replies.

matbuyer

Aerospace
Joined
Mar 15, 2016
Messages
4
Location
GB
Good morning,

Can you advise if it possible to heat treat L114 tube (20mmOD x 2mm Wall) from T4 into T6?

Thanks,
 
If the temper is achieved strictly through heat treatment, then probably yes.
If it depends in any way upon mechanical or thermomechanical treatment, then very likely not.
Contact a manufacturer and learn the processing route for this alloy.

"Everyone is entitled to their own opinions, but they are not entitled to their own facts."
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top