Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calibration of DC Shunts ranging from 1 mOhms to 10kOhms; Standard these can be calibrated to.

Status
Not open for further replies.
rkvbobby123

rkvbobby123

Electrical
Nov 18, 2014
26
I am at a lab that calibrates these shunts but does not list the standard these are calibrated to.
Does IEEE have a standard that the Lab must follow to assure compliance.
 
Status
Not open for further replies.

Similar threads

BMac57
  • Locked
  • Question
Adding 480V to Building
Replies
2
Views
1K
waross
waross
KH LEE
  • Locked
  • Question
NEC standard for Nipple
Replies
1
Views
807
waross
waross
Chopsider
  • Locked
  • Question
Identification of pressure switch operating range
Replies
3
Views
784
Chopsider
Chopsider
Engineer2021
  • Locked
  • Question
Ship electrical earth resistance value of 0.1ohm 1
Replies
4
Views
1K
Gr8blu
Gr8blu
trolex
  • Locked
  • Question
Class I, Division 2, rated accesories inside of typical NEMA 4X enclosure
Replies
2
Views
1K
trolex
trolex

Part and Inventory Search

Sponsor

Back
Top Bottom