Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Deform 3D simulation

Status
Not open for further replies.
Eddus

Eddus

Mechanical
Joined
Jan 11, 2019
Messages
2
Location
IN
error_are3ss.png


I am trying to simulate a drilling process using deform. The simulation does not run after beginning and ends at 0s (Everything's fine until database creation). I have tried out various simple examples from tutorials but everything ends up like this.
 
Sort by date Sort by votes
I've tried that there's no reply. But the simulation runs well for 2d.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Question Question
FEA Simulation of a Piezoelectric Accelerometer with Frequency Response Analysis
Replies
2
Views
9K
gnana_235
G
Harr2Plus
  • Locked
  • Question Question
Anodizing Simulation
Replies
5
Views
532
IRstuff
IRstuff
Ace-737
  • Locked
  • Question Question
welding simulation with SYSWELD 2021
Replies
0
Views
499
Ace-737
Ace-737
Jc1981
  • Locked
  • Question Question
Solid Edge Simulation
Replies
6
Views
678
Jc1981
Jc1981
ecto1000
  • Locked
  • Question Question
NX NASTRAN mesh 3d
Replies
16
Views
1K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top