Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to get analysis measurement feature into a relation

Status
Not open for further replies.

treddie

Computer
Joined
Dec 17, 2005
Messages
417
Location
US
Hi again.

In my previous post, "Creo Won't Let Me into a Group", I finally did a new installation of Creo 2 M100 and the old problems went away. One problem however remains, so I think this is user-error.

I am trying to get an analysis feature into a relation, but all my attempts are failing. I've done this before, but my procedure for this doesn't seem to work anymore ( and I didn't write this procedure down very well, either). The attached image shows the two methods I tried.

Creo knows the parameter exists for the analysis feature...it shows it in the parameter list. Yet the relation refuses to accept it, when pressing "Ok".
 
 https://files.engineering.com/getfile.aspx?folder=df808530-8e88-44ff-9999-53c8f5561eba&file=Analysis_Measurement_into_Relation_Not_Working.jpg
I read in a post somewhere that the option to put analysis features into a relation required additional licensing. I know that at least in my case, I never had any problems with this before (in the rare cases I needed it) and never required additional licensing for it. So not sure of the validity of that post.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top